top of page
Dynafluid 2000 logo.jpg

Thermostatic Hot & Cold Water Mixers

Dynafluid 3000 Thermostatic Hot & Cold Water Mixing Valve

 

The Dynafluid 3000 offers a straightforward and economic solution for instant, temperature controlled hot water on demand. Mixing high temperature hot water from a boiler or heat exchanger with cold water, the Dynafluid 3000 gives precisely controlled warm or hot water where it is needed, at the point of use.

 

Wash Down

 

The thermostatically controlled Dynafluid 3000 is the ideal choice for the washing down of walls or floors, carcass cleaning and vessel filling. It is the logical choice for any operation that has a ready supply of high temperature water that needs to be reduced to a lower temperature before it can be used. Typical uses include abattoirs, breweries, food production and processing plants, the petrochemical and processing industries - in fact, anywhere that hygiene is paramount.

 

Always in control.

 

The Dynafluid 3000 is a thermostatic valve that can be be provided with two different temperature ranges; 60-120°F or 100-160°F.  The standard valve can be adjusted from 100°F up to the factory-set maximum of 140°F and, in normal operating conditions, the temperature is held to within ±5°F. A manual override can increase the outlet temperature to a maximum of 160°F for particularly demanding cleaning operations that require water of a higher temperature. In the event of failure of the cold water supply, the valve will shut down within five seconds, preventing high temperature hot water from being discharged.

 

Tough and built to last.

 

This valve is specifically designed to operate in the harshest industrial environments. The main valve body is cast in gunmetal and the large adjustment knob and mounting bracket are in tough engineering plastic. Inside, the thermostatic and check valve cartridges are made in heat resistant thermoplastic polymers. The Dynafluid 3000 operates over a range of 10 psi to 90 psi operating pressure and 150 psi static pressure. End connections are industry-standard 3/4 inch NPT female threads, with 6 inch (150mm) pipe centres.

 

Key Features:

 

  • Instantaneous hot water.

  • Versatile—can be installed wherever a ready supply of hot water is available.

  • Safe—valve shuts down within five seconds if cold water supply fails.

  • Accurate—controls temperature to within ±5°F.Service-free temperature control cartridge.

  • Easy to service without removing from pipework—full spares availability.

  • Straightforward installation—requires no gas or electricity supply.

  • Complete with strainers and check valves.

Additional Information

bottom of page